PRODUCTION The entire production is separated in three phases: Procurement Section - From procuring the raw material to stacking all needed accessories & gadgetries & placing then in proper storeroom & storing yard. Sheet Metal Section - From getting the sheet metal from Yard to this section for cutting, bending & punching. Electrical / LPG Fitting - After completion all the sheet metal works, the source of energy is being fitted / connected by qualified & competent technicians. Trial Run - After finishing each product a trial run is being carried twice to as certain the optimum results & passed on to quality controller. Inspection by Quality Controller - After trial runs the quality controller goes through all the aspects of the equipments from sheet metal to final run to get the maximum output of the equipments. Installation & Service Manual - After delivering of the equipment a live demonstration is being carried out to the user / working hard & instruction manual is given. The working hand is being briefed about dos & don’ts & instruction is being given to prevent any mishaps. After Sales Service - With in the warranty period of 12 months, the organization carries out quarterly check up of the each & all equipments & keep enquiring through after sales department about the recent state. In case of any call, the follow up is being carried out with in shortest possible time. After the Warranty Period - After the expiry of warranty period if any call is made to us we do attend with minimum service charges & if any replacement or if any servicing is needed we do charge for the spares extra as optimum rates.